ER Dyno Day Results
#1
ER Dyno Day Results
I still haven't gotten around to installing my dual intank pump setup, so we decided to try a Q16 pull:
593/485 36psi
My fuel system is totally maxed out. (Single Walbro 255, stock fuel rail, and PTE 1200 injectors. Thank You ER for such a fun day.
John-
593/485 36psi
My fuel system is totally maxed out. (Single Walbro 255, stock fuel rail, and PTE 1200 injectors. Thank You ER for such a fun day.
John-
Last edited by JohnnyTSi; Feb 20, 2010 at 09:40 PM.
#4
The rest of my mods:
- 2.4 block modded for MIVEC oil feed
- JE 9:1 pistons
- Eagle rods
- Power Enterprise Head Gasket
- L19 Head Studs
- GSC S2
- fp springs
- AEM Exh. cam gear
- Modded MIVEC cam gear
- Magnus cast intake manifold
- PTE 1200cc Injectors
- ETS 4" Intercooler with short-route pipes
- Forge BOV
- ETS intake pipe
- Hallman Pro MBC
- FPBlack ported
- stock port matched exhaust manifold
- Megan O2 Housing
- Perrin 3" DP
- 3" Test Pipe
- HKS HiPower cat-back
Trending Topics
#12
Evolved Member
iTrader: (30)
We have made more than 550 tq, but really it still comes down to tune on the rod. I dont know what the max is on them but I would be surprised if it was any less than 600 ft lbs.
Congrats on the power Johnny...We'll get it back on the dyno and on something other than the Q
There was definitely more in it, just ran out of pump.
Congrats on the power Johnny...We'll get it back on the dyno and on something other than the Q
There was definitely more in it, just ran out of pump.