03 evo8 Dyno on E85
i'm no expert on ignitions so I couldn't tell you much. the first 3 mentioned above are comparable in price and quality. the last one, spoolinup is a nice kit for alot cheaper than the other but the quality is there. the guys uses factory toyota coils made by Denso. I think you'll be good with this setup unless you plan to go even higher and build an all out drag car. I know the typical gap is somewhere in the gap ranges you listed. if you get a COP you'll be able to run a larger gap too.
Buschur racing short block 2.3L stroker
Buschur racing stage 3 cylinder head
HKS 272 exhaust and Intake
Buschur racing ported intake manifold with a 65mm throttle body
Buschur Racing T67 P Trim Turbo Kit (37R)
Buschur Racing Evolution 3" Turboback Exhaust
Buschur Racing Double Pumper Fuel System
1600 cc injectors
Buschur Racing Evolution FMIC
Stage 3 shepherd racing transfer case
Bushwacker transmission
i think this is all i remember
Buschur racing stage 3 cylinder head
HKS 272 exhaust and Intake
Buschur racing ported intake manifold with a 65mm throttle body
Buschur Racing T67 P Trim Turbo Kit (37R)
Buschur Racing Evolution 3" Turboback Exhaust
Buschur Racing Double Pumper Fuel System
1600 cc injectors
Buschur Racing Evolution FMIC
Stage 3 shepherd racing transfer case
Bushwacker transmission
i think this is all i remember
Edit: Nvm i see you posted on.
Nice power for being on hks 272's, im sure there is a lot to be desired still running those.
Nice power for being on hks 272's, im sure there is a lot to be desired still running those.
Last edited by project_skyline; Mar 6, 2010 at 10:40 PM.
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
FS[South]: 2003 evo 8 low miles highly modified
smsevo8
For Sale - Cars For Sale
0
Mar 11, 2016 07:32 PM






