Fast_Freddie FP Red 93oct
Thread Starter
Joined: Jun 2007
Posts: 2,706
Likes: 15
From: Lexington Park, MD
Fast_Freddie FP Red 93oct
This is my graph from last month when I went down to Titan Motorsports to tune my car after moving to florida. R/TErnie and I had installed the FP Red about 2 weeks before my drive from Washington to Florida, and had previously tuned it on a Mustang in Oregon. This is MY tune not Erics, we have similar methodology when tuning, however I prefer to do stuff a bit different. I am set on getting the timing map as smooth as possible so there are nice smooth transitions between cells. Eric prefers to use interpolation, and he has excellent results with that.
As you will see there is not a torque or boost plot on this sheet. The RPM pick-up is very picky and we couldn't get it to work right one the car. At the time they didn't have a bosst sensor for the dyno as they had just aquired it.
418hp on STD correction and it was 417hp uncorrected FYI.
VDR Plot, as per Applaudds request... as you can see it is a bit different than my Dyno sheet...
Timing Graph
Boost Plot
As you will see there is not a torque or boost plot on this sheet. The RPM pick-up is very picky and we couldn't get it to work right one the car. At the time they didn't have a bosst sensor for the dyno as they had just aquired it.
418hp on STD correction and it was 417hp uncorrected FYI.
VDR Plot, as per Applaudds request... as you can see it is a bit different than my Dyno sheet...
Timing Graph
Boost Plot
Last edited by Fast_Freddie; Mar 12, 2010 at 02:31 PM.
Thread Starter
Joined: Jun 2007
Posts: 2,706
Likes: 15
From: Lexington Park, MD
Freddie, Nice job once again. The powerband looks amazing.
I'm starting to learn how to tune my car and I'm getting a small laptop and ecuflash in the next few weeks.
Also my car will be at ER next week for my motor build. We have decided to do a 2.4L 156mm long rod with 10:1 comp and S2Rs. Should be pretty nice. The plan is to keep the red for now but that may change down the road.
Mikey
I'm starting to learn how to tune my car and I'm getting a small laptop and ecuflash in the next few weeks.
Also my car will be at ER next week for my motor build. We have decided to do a 2.4L 156mm long rod with 10:1 comp and S2Rs. Should be pretty nice. The plan is to keep the red for now but that may change down the road.
Mikey
