Welcome2GoodBur

I finally had the chance to get my car dialed in by Tom over the summer. I'm very happy with where the car is, as the mods are minimal, but the gains are awesome. I wanted to get a print out on an actual dyno just to see where I was at, and I am pretty happy with how it turned out. Thanks to Cody at Redline Tuning in Ohio for letting me use the rollers. Word on the street is that this particular dyno reads a bit low, but it seems like it is right around where it should be.

Mods:
Tomei Poncam 270
STM 3.5' SD intake
FIC 1100cc injectors
Walbro 255
BR Bullet exhaust (resonated test pipe)
EGR block off/emissions delete
Speed Density
E85
~27PSI

dookgvr4

iTrader: (14)

SW20Mike

iTrader: (6)

^ I'm curious too, can you post the VD graph. I'm assuming you are running a 3 port boost solenoid or MBC? 400 Whp should be easy with a few simple mods.