Alright guys I recently purchased a Saga V2.0 boost gauge(amber/psi). Info can be seen here
https://www.evolutionm.net/forums/sh...ght=saga+gauge
Anyhow I love the look of the Defi's, however this seems to be a very nice cheaper alternative(and I wanted to try something different). I plan on buying a few more if I like the boost gauge. My initial impressions are high. (Will post pictures after installation)

My question is when hooking up the gauge electrically, it has five different wires as apposed to Defi's 4. Layout is as follows.. Black(ground), orange(constant power), yellow(ACC), brown(it says small lamp?) <-- I am assuming this is like Defi's white wire for the lighting.. And finally a Red wire which says(B+)

Does anyone know what the red wire, or B+ means? I apologize ahead of time if this is a retarded question that has an obvious answer, but I do not know. Which means I cannot install the gauge yet.

So if you have any thoughts or suggestions please let me know. Thanks ahead of time.

 

B+ is constant power rather ACC(ignition) which on yours is yellow

 

Ive seen B+ on marine gauge applications before and it is marked B+ for battery. It gets hooked a "key on" +12vdc power source

 

Alright it says specifically for the orange to be on the constant hookup.. So I just have two constant wires? Thanks again Also the brown wire would be for dimming correct.

 

pictures available yet? I thought these were only available in metric! That's sweet that american readings are available. How is the quality of these?

 

GSX, how are these gauges working out for you??