Dual din people
+1
My double din doesn't fit flush either, and I keep reading to re-adjust the radio brackets. I just don't want to "trial and error" the stock radio brackets. Does anybody have specific guidance as to how to readjust the radio brackets specifically?
My double din doesn't fit flush either, and I keep reading to re-adjust the radio brackets. I just don't want to "trial and error" the stock radio brackets. Does anybody have specific guidance as to how to readjust the radio brackets specifically?
I just answered my own question. The stock hole location sets the unit tilted up, protruded, and high.
To make it fit flush, I drilled another hole that is about 1/4 inch below and behind the stock hole location on the bracket anterior hole. I also only used this hole to attach the screw to the double din unit, to make it easier to tilt down.
*Disclaimer: I cannot guarantee that this will work for other double din units, but worked for my Kenwood, so do it wisely.
To make it fit flush, I drilled another hole that is about 1/4 inch below and behind the stock hole location on the bracket anterior hole. I also only used this hole to attach the screw to the double din unit, to make it easier to tilt down.
*Disclaimer: I cannot guarantee that this will work for other double din units, but worked for my Kenwood, so do it wisely.
Thread
Thread Starter
Forum
Replies
Last Post
AHAZZARD
Evo X Electrical / Audio / Security
2
Nov 24, 2009 11:01 AM
the_cosworth
Lancer How To Requests / Questions / Tips
7
Jan 10, 2009 04:50 PM
