I was wondering whats the easiest way to run the wires from the ecu and handbrake back to the unit?

 

The easy way for me was the following; run the wires under your stearing colum and behind the center console area, you'll have to remove the entire center console. Run the ebrake wite up the center of the console near your shifter housing, use some tie downs to keep it from moving, then splice into your ebrake (on a side note , dont use the spilcers that HKS provides, they are complete crap and would never close all the way, go to radio shake and get some better ones). Next run the two ther wires to your ecu from behind the center console. This is as far as I can take you as I didn't splice the other 2 wires into my ecu, to scared to scrw the splice up and render my ecu dead.

 

Just remember leave at least 3" between any connector and a wire you're splicing, that way if it gets cut you have more than enough room to strip it and resolder them.