Precision Shaft Technologies

Reply Subscribe

Thread Tools

Search this Thread

Aug 12, 2005 | 03:04 PM

RyanM

Thread Starter

Evolving Member

iTrader: (1)

Joined: Aug 2004

Posts: 362

Likes: 0

From: Otley, Iowa

Precision Shaft Technologies

http://www.pstds.com/driveshafts.cfm

Has anyone used them to make drive shafts for an Evo? They look like they have a good product, cryo treatment is a big plus.

I don't have the data, does any one have the info below for our cars?

diff
Rear U-Joint Cup Diameter
Dimention W Trans seal to Diff Seal
Dimention X Trans seal to center of rear U-Joint
Dimention Y Trans seal to center of Center bearing
Dimention Z Center of center bearing to Diff seal

Last edited by RyanM; Aug 12, 2005 at 03:09 PM.

Aug 12, 2005 | 03:16 PM

TwStDeVo

Evolved Member

iTrader: (62)

Joined: Oct 2003

Posts: 1,672

Likes: 0

From: 5o5

not sure about any specs, but Driveshaft.com makes different staged rear axles. i think Al from Dynoflash has one that is rated up to 900hp. you can get them at buschurracing.com

Aug 13, 2005 | 08:36 AM

RyanM

Thread Starter

Evolving Member

iTrader: (1)

Joined: Aug 2004

Posts: 362

Likes: 0

From: Otley, Iowa

bump for PST users?

Aug 29, 2005 | 07:57 AM

RyanM

Thread Starter

Evolving Member

iTrader: (1)

Joined: Aug 2004

Posts: 362

Likes: 0

From: Otley, Iowa

I spoke with Precision Shaft Technologies today, they will make Evo axles. I am going to send my 2004 OE units to them. Their prices are FAR more attractive than most anything else out there. Check out their website.

http://www.pstds.com/driveshafts.cfm

If anyone else is interested, PM me or contact them directly. The name of the engineer working on this is Mark.

Very nice folks to deal with!!!