Notices
Evo Engine / Turbo / Drivetrain Everything from engine management to the best clutch and flywheel.

bleeding lifters

Thread Tools
 
Search this Thread
 
Old Aug 27, 2005 | 08:48 AM
  #1  
keviin's Avatar
Thread Starter
Evolved Member
iTrader: (2)
 
Joined: May 2003
Posts: 581
Likes: 0
From: Vacaville, Ca.
bleeding lifters

on the evomoto install page.. if they had bleeding lifters.... what step # would it be?
Reply
Old Aug 27, 2005 | 08:54 AM
  #2  
matt55's Avatar
Evolved Member
iTrader: (12)
 
Joined: May 2003
Posts: 1,734
Likes: 1
From: NC
befor u put the NEW cams in
Reply
Old Aug 28, 2005 | 11:31 AM
  #3  
Mooshu1221's Avatar
Account Disabled
iTrader: (6)
 
Joined: Dec 2004
Posts: 154
Likes: 0
From: New York
did they update for installation instruction yet with the bleeding the lifters?
Reply
Old Aug 28, 2005 | 11:38 AM
  #4  
Curt@MrLed's Avatar
Former Vendor
iTrader: (107)
 
Joined: Sep 2004
Posts: 4,364
Likes: 0
From: A.K.A. DaFarmer
look one these last couple pages to find the link to the how too..

https://www.evolutionm.net/forums/sh...d.php?t=135316
Reply
Old Aug 28, 2005 | 11:45 AM
  #5  
Mooshu1221's Avatar
Account Disabled
iTrader: (6)
 
Joined: Dec 2004
Posts: 154
Likes: 0
From: New York
looking for some picture instructions.
Reply
Old Aug 28, 2005 | 11:49 AM
  #6  
Curt@MrLed's Avatar
Former Vendor
iTrader: (107)
 
Joined: Sep 2004
Posts: 4,364
Likes: 0
From: A.K.A. DaFarmer
as i said, search, you will find it.. im am to busy to look for it..
Reply
Old Aug 28, 2005 | 11:51 AM
  #7  
Curt@MrLed's Avatar
Former Vendor
iTrader: (107)
 
Joined: Sep 2004
Posts: 4,364
Likes: 0
From: A.K.A. DaFarmer
http://www.joe250.com/cars/evo/camshaftinstall.htm

here dammit..
Reply
Old Aug 28, 2005 | 11:54 AM
  #8  
matt55's Avatar
Evolved Member
iTrader: (12)
 
Joined: May 2003
Posts: 1,734
Likes: 1
From: NC
btw you might have to use a small paper-clip , I didnt have a allen wrench small enuf to push the check valve open...
Reply
Old Aug 28, 2005 | 06:04 PM
  #9  
Mooshu1221's Avatar
Account Disabled
iTrader: (6)
 
Joined: Dec 2004
Posts: 154
Likes: 0
From: New York
thanx for the info dude
Reply




All times are GMT -7. The time now is 02:21 PM.