So I bought a Megan CBE from a member here on the forums and I had a little issue when trying to install it...

After we took the stock exhaust off and tried to install the Megan it wouldn't bolt up to the cat. After we looked at the mounting flange and compaired it to the gasket, the mounting holes were off by about 1/8 of an inch or so. Upon closer inspection one of the holes wasn't even shaped right.

I am going to enlarge the hole a little tonight and try again tonight.

Overall, not a huge problem, but a problem none-the-less

 

yea, that was a issue with people bolting this catback to stock cat...i had to dremmel out the holes for it to fit...it worked for a few days before i just swapped on the test pipe..haha..

 

Yeah, test pipe and down pipe are next on the list, but I am too impatient to wait. Haha