Notices
Evo Engine / Turbo / Drivetrain Everything from engine management to the best clutch and flywheel.

2003 no lsd issue?

Thread Tools
 
Search this Thread
 
Old Oct 23, 2006 | 12:53 PM
  #16  
Jeff_Jeske's Avatar
Evolved Member
iTrader: (66)
 
Joined: Jan 2003
Posts: 4,358
Likes: 7
From: On the track
I have the ralliart front LSD in my 2003 EVO. I dont have any ABS problems at all. This car sees plenty of track time but I rarely if ever launch the car. I'm still on the stock clutch at 30K miles. The difference between the open diff and the ralliart diff is night and day. That is if you actually push the car hard enough to use LSD. Prior to the LSD my car plowed alot. After the LSD I can induce throttle oversteer at will. So much in fact that I had to soften up my rear sway bar.
Reply
Old Oct 23, 2006 | 01:20 PM
  #17  
gsrboi80's Avatar
Evolved Member
Photogenic
Photoriffic
Shutterbug
Liked
iTrader: (38)
 
Joined: Aug 2005
Posts: 7,909
Likes: 47
From: On a cliff
The front LSD in her 04 RS is very noticable over the open diff in my 03. Any front LSD for either the 04 RS or 05+EVOs will swap into 03 no problem from what I've been told
Reply
Old Oct 23, 2006 | 04:38 PM
  #18  
JoizeeX's Avatar
Evolving Member
 
Joined: Nov 2004
Posts: 473
Likes: 0
From: Maple Shade NJ - All ur base r belong to us
Originally Posted by Jeff_Jeske
I have the ralliart front LSD in my 2003 EVO. I dont have any ABS problems at all. This car sees plenty of track time but I rarely if ever launch the car. I'm still on the stock clutch at 30K miles. The difference between the open diff and the ralliart diff is night and day. That is if you actually push the car hard enough to use LSD. Prior to the LSD my car plowed alot. After the LSD I can induce throttle oversteer at will. So much in fact that I had to soften up my rear sway bar.
Jeff, when u had urs installed, they only needed to remove the passenger axle and side transfer case plate, right? how much was labor? (assuming u didn't do it urself)
Reply
Old Oct 23, 2006 | 09:04 PM
  #19  
Jeff_Jeske's Avatar
Evolved Member
iTrader: (66)
 
Joined: Jan 2003
Posts: 4,358
Likes: 7
From: On the track
I did the install myself, Even though I have two complete transfer cases, I opted to pull the xfer case apart and swap the internals. When doing mine, I yanked both axles. The job was VERY easy and didn't take but a couple hours taking my time.
Reply
Old Oct 23, 2006 | 09:04 PM
  #20  
Jeff_Jeske's Avatar
Evolved Member
iTrader: (66)
 
Joined: Jan 2003
Posts: 4,358
Likes: 7
From: On the track
delete

Last edited by Jeff_Jeske; Oct 23, 2006 at 09:16 PM.
Reply
Old Oct 23, 2006 | 09:04 PM
  #21  
Jeff_Jeske's Avatar
Evolved Member
iTrader: (66)
 
Joined: Jan 2003
Posts: 4,358
Likes: 7
From: On the track
delete

Last edited by Jeff_Jeske; Oct 23, 2006 at 09:16 PM.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
worksevo89
Evo Engine / Turbo / Drivetrain
18
Jun 13, 2008 05:46 AM
Carrier
Lancer Tranny/Drivetrain Tech
11
Jan 24, 2008 07:59 AM
riceball777
Evo Engine / Turbo / Drivetrain
11
May 10, 2007 09:39 AM
Carrier
Lancer Tranny/Drivetrain Tech
9
Apr 27, 2006 10:29 PM
Carrier
Lancer General
4
Dec 28, 2005 07:40 AM




All times are GMT -7. The time now is 09:30 AM.