Pruven installed my hks 264/272 cams

Most threads I read aBout tapping is when engine is at idle

Mine doesn't really tap when at idle

it taps if I rev up to 1500-2000 rpm , is this a lifter causing it also?

thanks

 

yes. mine tap at idle and when i rev it to 2k rpm.

 

so is this just as bad? how do I get rid of it if it isnt good for the car??

 

did you bleed the lifters??
you must bleed them!

 

Pruven peformance installed my cams, so I dont know if they bled them. Anyone else had their cams installed at pruven??

 

No but the ticking is just annoying...the car is not going to break or prematurley wear out.

 

Ok, I mean I dont mind the ticking b/c its only at very low rpm but as long as it isn't bad for the car. It would be a pain in the *** to get it reinstalled.
I just thought if it was the lifters it was bad for the car?

 

My engine with stock cams makes this tap noise between 1500 to 2000rpm.

I do not know if it is a lifter or a thin oil or a normal noise on the 4G63

 

the 4g63 is really noisey.. Evo motors are a lot better than the dsm's though

 

I dont mind the noise, just that the sound wasn't there with the stock cams