I have been told two diff storys on what to expect from the GT35R.
I'm going to get a .82 hotside and i want to run 30 psi or so. What do you think i could expect from the upgrade i have a built motor. the only thing that is stock is the turbo and man and intake man. Just need feed back to make it better

 

It really depends on the kit you choose, your supporting mods and of course the tune. Plan on making anywhere from 400-450whp on pump gas, 500-550whp on methanol and that could be about it for most kits. I made 598whp on race gas and 30psi (but could've done it on pump+meth) with the ETS kit but have seen numbers as low as 508whp at 32psi with other kits.

Tom

 

i put down 418awhp on 22 psi 92 octane.no meth.i had stock block,stock intake mani,stock head.parts are in my sig.

also had a stock slipping clutch.oh and stock uicp at the time...it was a pretty conservative tune...i think now with uicp,new clutch and get rid of my greddy IC i can put down a lot more on same psi...

 

There are multiple threads on engine/turbo/drivetrain right now of GT35R cars we have been sending out of here with dyno charts. Check them out.

 

post your dyno sheets when you're done doing whichever

 

i do have alky injection also i hope to get 550hp

 

where you running that stock ecu with a flash and a maf

 

i havent seen any evos with over 550whp on the stock ecu but i might be wrong. also the descrepency in power that you were mentioning tom could be due to descrepency's in dyno's, altitude, temp, humitidy, tune, ect not just the turbo kit. btw stomper since you live in utah and i do too you should give me a ride when you get this kit installed pm me

 

you can see my numbers in my sig.

 

AEM EMS is what he made those numbers on

 

Steve is correct. I was at 30psi on C16 with an AEM EMS running speed density. We've had customers make almost the same power I made at lower boost levels using our parts with flashes so it's most likely a combination of both.

Tom

 

I put down 602hp and 546 ft/lbs of torque on C16 and 37psi!

 

Well i got it tuned the other day on a dynopak. It is running 28 PSI and i made 571 awhp. On 91 and alky stock ecu and maf with 1000cc injectors.
I will post the dyno sheet here i a bit.

 

^^
please do post it
really want to see it

 

im puting down 530whp on 28 psi 93 octane + meth
dyno jet
gt35r