Check out the attached pic. The lower radiator hose is/has been pressing up agains the linkage from the slave cylinder.

I'm a bit embarrassed to say that Mitsu has done most of my mods and did the last ones I had done, so I'd not noticed it 'til today. But I don't see how to move it since it's a formed hose, right? It's up against the Buschur intake pipe above it, more or less, as well.

Anybody have any ideas how to get this all to fit???

Thanks.

 

Anybody have this problem/know how to deal with it? *BUMP*

Thanks!

 

That's how it do. Kinda sucks. Intakes usually make things a little worse and press the hose into the linkage.

 

Aw, c'mon, someone's dealt with this with success, yes?