1-piece Driveshaft
Apr 21, 2009, 05:51 PM
#1
Evolving Member
Thread Starter
iTrader: (9)
Join Date: Jun 2008
Location: Parkville, MO
Posts: 126
Likes: 0
Received 0 Likes
on
0 Posts
1-piece Driveshaft
Why has no one made one? I figured the only reason would be because there would be too much sag in the driveshaft. I was thinking about doing this for my car.
Apr 28, 2009, 11:03 AM
#4
I've been running the numbers and unless you can get a very stiff shaft, you are going to have too low of a low natural frequency.
I think you won't be any where near stiff enough to run a full length shaft with a metal driveshaft. A composite driveshaft might do it though.
I think you won't be any where near stiff enough to run a full length shaft with a metal driveshaft. A composite driveshaft might do it though.
