I was on a site that sold the Manley rotating assembly kit. Basically consists of their forged pistons, rods, and new crankshafts. Along w/ standard sized bearings etc...

my question is has anyone used all of their components together? (more importantly the crank) and if so... did they fit perfectly when checked by a machinest etc? They're priced competively and i know Manley is a good brand, but just seeing if there has been any feedback on these internals. Thx


-Tom

 

From what I know of Manley they do out source some of their product to China. I know the H-Beam rods are China made. However their I-Beam Turbo Tuff rods are made here in NJ.

Not sure on their pistons though

 

the h-beams are made in China?! whoa... so im guessing the Eagles are also. I can upgrade to the TT I-beams. What about their crankshafts?

 

For the price of a Manley crankshaft, I would bet money that they're not made here, Japan or Europe

From what I know, Manley, Eagle and Scat forged H-beams all come off the same assembly line.

 

Couldn't make a comment on there crank, but i know there rods are good.....

 

Yes as are the Eagles. China made.

 

thanks! that makes alot of sense i have to agree... Well im sitting on their forged piston set and their rods. I have the h-beams... but now thinking about getting the turbo-tuff or the 300m and just eating the cost. I'll stick to a stock crankshaft then that i also bought from another member. Thanks guys.