Notices
Evo Engine / Turbo / Drivetrain Everything from engine management to the best clutch and flywheel.

Rear end went out after clutch install

Thread Tools
 
Search this Thread
 
Old Jan 26, 2010 | 01:00 PM
  #16  
howell's Avatar
Evolving Member
iTrader: (2)
 
Joined: Jan 2010
Posts: 161
Likes: 0
From: newark ohio
Originally Posted by turbolarry
Check the transfercase. It comes off on a clutch install and if it was drained and not refilled... Well, when it locks up you get the "anchors away."
... and you heard a whining noise...
Locked transefer case, locked driveshaft, still rolling = biffed rear end (maybe).
I hope that's not what happened but, sounds like that Could be what happened.
Reply
Old Jan 26, 2010 | 02:46 PM
  #17  
Evoguyfhp's Avatar
Thread Starter
Newbie
iTrader: (5)
 
Joined: Dec 2007
Posts: 87
Likes: 0
From: Gainesville Fl
transfer case was told is fine just the diff sooooooo ya i dont know weird stuff weird stuff just a random mishap it had fluid oh well **** happens . ty guys
Reply
Old Jan 26, 2010 | 02:53 PM
  #18  
EVODreams's Avatar
Evolving Member
iTrader: (7)
 
Joined: Feb 2004
Posts: 244
Likes: 0
From: Fort Walton Beach, FL
I would bet money your transfer case is not fine. This same situation happened to me just about 3 weeks ago. The transfer case leaked all of the fluid out the back of it and locked up at 60 destroying my rear diff. I thought it was just my rear diff too, but guess what happened when I replaced the rear diff...car could go about 30 ft and then would bind up. You can still move the care with a bad t-case, but I would tell them to look again!
Reply




All times are GMT -7. The time now is 07:09 PM.