Just got my head back from headway performance looks amazing (dont mind the cell phone pictures) CNC port and polish, O-ringed, Valve job, New guides, Supertech dual springs, Supertech Ti retainers, Supertech intake and exhaust valves. Going to be running kelford 272's on this head for now.

 

Looks damn good.

 

Looks pretty good.

 

head **** is always lovely

 

Looks nice, but how does it flow?? Can you post up the pre and post port flow numbers for both intake and exhaust (.100-.500 lift @ 28") as well as the before and after volumes of intake ports, exhaust ports and combustion chambers?

 

i dont have the specific flow charts for my head, for general idea he does have something post on his website about it. Maybe when i pick up my block i will ask if he has paperwork

 

Can I ask what this job ran you $$$ wise?

 

The Headway Performance CNC port programming obtains about as much flow as can be had from an EVO head without making a water well. Don't ask me how I know this.

 

Motor is going to be r&r aluminum rods, wiseco hd pistons. Can't wait to get it together

 

How much did the CNC Headway Head cost?

 

Holy crap 155whp gain over a CNC Cosworth head and cams. That is amazing if it's true.

 

i would like to know also and how does it compare to the buschur stg3?

 

lol would not doubt the head is 2000 or alittle more

 

Head way is the way to go his shop is right up the block form me he done all my honda motors for me and now my evo motor he is a very good friend HEADWAY FTW!!!!

 

Looks super nice. I noticed you in CT. Is this shop close to you?