So I am getting ready to install a new clutch/flywheel this coming Saturday. I also have a Whiteline Precision Steering Kit to throw in while I'm digging in there. I would like to know what else would be a good idea to do as far as minor upgrades while removing/installing the clutch on a lift. Thanks!

 

No one? I'm throwing in an STM SS clutch line. Anything else?

 

remove the restrictor pill from the slave.

 

yea i am not even sure if the previous owner removed it or not but def will if its still their

 

If any of the mounts are bad, you can replace them a lot easier at this point.

 

already did sides and front

 

Clutch fork stopper?

New TOB?

 

i read that i wont really need a clutch fork stopper for a single disc and i got an OEM TOB

 

New flywheel bolts + red loctite

 

got em

 

Sounds like you got it covered. Did you have anything on your mind.

 

A front swaybar if you need one.

 

hmmm i did consider front sway bar bushings...but its too late to order parts now!!! oops

 

OP, I just took out my transmission for a new clutch and to get the transmission rebuilt last night.

http://www.mitsubishiparts.net/catal...tion=1155#2530

The guy whos rebuilding it also recommended to replace the clutch fork and also to get this kit.

Evolution VIII IX CT9A Clutch Release Fork Shaft Kit

My release fork shaft was worn down a bit as well as the clutch fork. Those springs and felt pads are things you should replace as well since your in there.