I was looking to swap my mivec line for a stainless set up with an fittings so I don't have to worry about it leaking anymore (already is). I've seen the lines that map, stm and buschur make but the problem with those is they use the stock banjo bolts (which I never got the smaller sized one back from the shop that built my engine). So I was wondering if anyone had their mivec line apart and could give me size and pitch of the banjo bolts. I would measure them myself but the car is in Washington and I'm in Alaska. Any help is appreciated.

 

Bump

 

Bump

 

ttt