Clutch job, Things to replace?
#1
Clutch job, Things to replace?
So my car has the typical 3rd 5th grind and the clutch is starting to go too so now its time to get busy.
I went and ordered a used tranny without any problems so I can potentially rebuild my current one on the side if need be. Leaning towards twin disc because I wanna hit some higher numbers down the road and everyone is leaning towards triple. Just wanting to see what everyone would do to get the job done right since its that time. And possibly how much fluids it takes to change below.
My list so far:
New TOB
Tranny oil: Redline mt90 gear oil
Transfer case oil: Mitsubishi diaqueen
Rear end oil: Mitsubishi diaqueen
Potential: (let me know if any of these are not really necessary)
Slave cylinder
braided clutch lines
Map Clutch fork stop
Wave lock retaining clip?
I went and ordered a used tranny without any problems so I can potentially rebuild my current one on the side if need be. Leaning towards twin disc because I wanna hit some higher numbers down the road and everyone is leaning towards triple. Just wanting to see what everyone would do to get the job done right since its that time. And possibly how much fluids it takes to change below.
My list so far:
New TOB
Tranny oil: Redline mt90 gear oil
Transfer case oil: Mitsubishi diaqueen
Rear end oil: Mitsubishi diaqueen
Potential: (let me know if any of these are not really necessary)
Slave cylinder
braided clutch lines
Map Clutch fork stop
Wave lock retaining clip?
Thread
Thread Starter
Forum
Replies
Last Post
huevosrancheros
Evo Engine / Turbo / Drivetrain
3
Apr 14, 2009 04:41 PM