So i replaced my whole exhaust and my o2, went back to stock. But now that I have the car all back together, when I started it up I was getting smoke from my exhaust mani, hotside and my o2. I was wondering if it could be because i sprayed pb blaster all over them trying to get the stupid bolts off. Any help would be amazing you guys. For now my even is down and its my only method of transportation.

 

Yes I would say its the PB blaster you used if only the 02 housing and and exhaust were replaced.

 

sounds normal, all that spray is burning off.

 

Do like Bill Clinton and don't inhale!

 

So everything is normal? How long should I let it run? And advice on how to burn all of it off?

 

sounds like its leaking muffler fluid for sure. check the specs on the endline for the rotary girder...if there's excessive play in the linkage, make an appointment with your tuner, he can tune it out. good luck!

 

How long should I let it run for?

 

HAHAHHAHAHAHAA TOMMY BOY!!!!! ("I'm retarded")

 

Untill it stop smelling/smoking. Just drive the car like normal and monitor it.

 

Yea just continue driving it, it should burn off in a few miles.

 

Can there're be any serious damage done to anything while it smokes?

 

^No. You just get to enjoy the smell for a while.