sweet man! That is a very nice streetable clutch. Once the beast is done we will have to go out to some meets or something.

PJ

 

Swapped the stock BBS w/ stock Advans for EVO VIII's with Dunlop SP Winter Sport 3D's.

She's dirty as fawk! She def needs a wash and bad. It sucks though because I leave for work at 8:20am, and get home at 6pm-ish. It's too early and too late to do anything!!! Sunday's are my only hope, but it's now 40°F< and I'll be in Vegas/Phoenix from Thursday-Sunday.
Vegas thurs, fri, sat with the boys, and Phoenix on sun to watch the giants/cardinals game.

-Jalal

 

got it all clean and purdy to sell. boo hoo.

 

oh, and i fixed the alignment. home alignments for the win. i don't trust those big laser rack things.

 

Installed a new Schroth harness and went for a test drive, very nice belt set-up.

 

Last night I installed the Perrin FMIC, Nisei piping kit, Silverstar Ultra headlight bulbs, and stuffed my catch-can.

 

Nothing! Dealer has it, replacing 3rd gear syncro and bearings. Also putting in new clutch while they are in there. Oh, and this is a warranty repair. So I've been rockin' a 08 Tundra for a week now on Mitsubishi's nickle.

 

Installed oem mitsu rain guards, cheya

 

Absolutely nothing!. I've been stareing at picture of my evo before storing in Army storage. Its been long 13 months. 2 more to go!

 

- changed the oil,
- bleed brakes w/ Motul RBF600,
- removed the back seats and gutted the trunk,
- changed out the Project Mu pads w/ Performance Friction pads,
- filled up some cans with 100 octane and will fill the car up soon too,
- loaded up the back with some Volks 17x9.5 with TA1's mounted,
- loaded up tools, stands, jack, etc.,
- and waiting to drive to down to the AutoClub Speedway for some "roval" action

 

Changed oil + filter, fixed EGR vacuum leak under the manifold that was causing CEL, and a friend came by and washed, vacumed, and waxed it. Also, its getting colder so I'm letting it run for an extra 30 seconds in the morning before setting off.

 

dropped the cross bars and dp on my 15 minute break at work then on my lunch break replaced the doughnut gasket buttoned it all up and had time to go grab some grub

 

I haven't done anything to her today.

But I do plan on pulling the engine out tomorrow night!

 

Finally installed the Last of my CUSCO power braces.
Now i have every Cusco power brace they make on the car. hehe..

CUSCO Power Brace for the rear of the trunk.



Had to cut/dremel the plastic piece that covers the trunk latch area so it would fit with the cover on.

Looks good, we'll see if it stiffens the rear up a bit more than it was.
Prob. not but it still looks sweet with all the Braces on.
"Especially underneath the car."

 

Rally armour flaps!