started it after a week ... the weather is pretty ****ty out here in NYC to drive

 

Clocked my hta86 so that it was perfectly vertical and found where my oil leak is coming from! Damned oil sprocket seal!

 

I did a oil change and a car wash.

 

Gave it a bath and installed Spoolin Up COP!!! She's running like a beauty now no more p0300!!

 

Tried to push it ip my driveway and into the garage... And failed... :-(

 

Drive it to the carwash, I was like damn I gotta drive this thing more often

 

Installed Torque Solutions underhood shifter bushings. Good improvement in shifter feel.

 

Nothing. Still looking to buy one. No luck!!

 

definitely should!

 

Started the fun process of taking out/drilling out every horrid looking, rusted *** oem fastener under the hood of the car. No amount of PB blaster/heat is saving me here, seems like most of them just want to snap right off. At least they will drill out easy if they are that soft......

Going to take the hood off for a winter restoration as well. Looking forward to sanding until my hand falls off.

 

Pulled turbo out because of A seized turbo to Mani bolt. Sending my fid Mani to get coated and rtv'ing my lower exhaust Mani studs that so happened to leak.

 

Worked on my custom gauge pod... Almost done, just needs paint

 

I had a Cobb CBE installed!

 

(Actually yesterday...)
Picked it up from the shop after they rebuilt my coilerover setup. Rides so much better!

 

Im diggin the custom Guage pod Eflores
are you on the VA beach Evos Page?