Perhaps someone could provide a pic (should be easy, just remove the tabs/license plate and take the picture). I recently went to the dealer for the two bolts that go through the front bumper cover and screw into the two tabs on the bottom of the front crash beam. However, looking at the brackets on the front bumper and looking at the bolts, it seems like they provided the wrong ones as the bolts look like they would just go right through the holes (diameter of the head not large enough). Would someone be able to provide me a pic or part number to make sure I have the correct bolts? Thanks all in advance!

 

Anyone?

 

i can send you mines if you want, just pay postage..

 

 

Do the thread in? Just use washers.

 

ak47, I have that picture, but when I went to the dealer and got the bolts (I even showed him the picture), they just dont seem wide enough at the head and almost fit through the holes. Is there some rubber bushing or something that goes on the bumper brackets themselves or is it just a bolt? I wonder if someone would have a part number?

 

The part number I had for the two bolts is MS240179. Basically, I would need someone with an IX to pull the little tab on the passenger side and just take a picture of the bolt inside there so I can see the actual size of the head. If anyone would be willing to do this I would appreciate it!

 

Could you drop me a pic of them?

 

Surely someone could pop that little cap off and take a pic for me?

 

i will tomorow

 

Thank you!