Thanks! Anyone else got some pics??? That's what I asked for in the original post. The cage is for Drag. Looking at an 8 point. Two in the trunk, two up front on the floor, four behing the drivers and passengers seats.


[QUOTE=Indy Evo;7768452]Here is the one we did for 9sec9.

 

if you go for drag, then try to get a simplest and lightest cage is approvable for the track.
Dont pay too much attention how many point it is . Just try to get a minimum required cage for drag.
Its a drag race, so every little bit is counted for.

 

Dont mean to hijack the thread but what bottle is that in 9sec9 car, for that buschur autolaunch setup or something like that???

 

Anyone else got pics?????

 

I think it's part of the boost control system

 

It's for a AMS1000 boost controller. For more info go to AMS1000.com.

 

I'll have a custom made 4-pt in about two weeks, my best friend's building it soon as my car gets out of the body shot... will post many pics.

 

Dennis, i just had one done by madcap racing, it's a 6 point cage, i get get pics for you if you want them.

 

what cage do i need for 9s?

 

one of the best if not the best boost controler available i say one of the best because ive seen world electronics factory and there tbc-1 is a very nice piece also enough of my off topic boost control talk and bump for more cages if its a cage for a drag car i would get on nhra website they change the rules yearly for alot of things dont wanna get to a event like ams did and not be able to run your car.

 

there is a chassis builder in WA that has done a couple cages for evo guys for around 2k and I believe one was chrom-oly and both were for drag. ill see if I can get his name tomorrow