alright so i had an evo before i got my 9 mr and i have a k&n filter and an maf adapter that were only used for about 5k miles laying around in my garage. would this be a good intake to use. i have heard that the perrin intake is the best you can get, but how much better would it be that this? i mean i am using the oem plumbing just changing the filter. would i be better off to just get a k&n panel filter and use that in the stock box. any input would be great thanks.

 

I am running an Apexi filter on a MAF sensor adapter and love it. (intake piping)

 

so is it better to get new intake piping too?

 

Depending on your future goals with the car. If you plan on modding, you might as well go for the intake pipe too, you will eventually want/need it.

 

i am keeping it easy not doing anything crazy at all i was going to do a tbe and intake with an intercooler and fuel pump just kinda givin it some more power

 

I hear ya, that's usually the 1st steps we all took. You don't need an intercooler if that's all you plan on doing. I would highly suggest a tune and a Manual/Electric boost controller and you'll be set!

 

We all did that, now we just add a little bit here and a little bit there.

Good Luck with the car

 

I had stock intake with K&N which works fine, i upgraded about 2 weeks ago to the perrin..a world of difference and works perfect untuned. No idle issues or anything I definatly reccomend it.

 

that really depends on your goal. If I had to do over again, I would have plan it better. I too had the K&N and went with the Perrin route.

 

perrin/apexi filters are proven to yield the best gains vs cleaning abilities

search for more info

closed...