very nice if you dont mind me asking how did you get it for and i think i may have a few of those parts you need chilling in my house if you need them i can ship

 

Sweet new ride!

 

good luck!

 

Good luck

 

I'm not going to say how much I paid for the car but after I get it running and driving it should end up being a pretty good deal, even with the tranny needing to be rebuilt.

 

parts that I got so far:

oem intercooler pipes from emery at STM
oem exhaust from an 06, my buddy brought it down for me from a guy in Rochester
alternator off ebay
shift knob off ebay
belt tensioner off ebay (still waiting for this)

 

I used to just PM the seller. i think the rule is just no posting in the for sale.

 

got the exhaust on but the downstream oxygen sensor must be in a different location on the 06, the harness isnt long enough:

 

I have the timing kit with all the pieces and belts.

 

I need the serpt belt tensioner assembly not the one for the timing belt

 

The evo9s (2006 models) have the o2 in the cat. Evo 8s had them in the mid pipe after the cat. Good luck

 

ahhh ok well that makes sense. Wish I knew that before I bought it but hopefully it works. I asked and searched the forum but of course everyone said that it would work fine and that maybe the only difference was the downpipe for ACD clearance

 

Just cut and extend the wires have done this with no problems on many header installs on V8. Make sure to use weather proof conectors or shrink wrap. Good luck with project i am also doing a repo build.

 

OR just plug the o2 at the cat and go to the muffler shop and get a bung put on in the midpipe... OR just leave the rear o2 sensor unplugged. Cutting and extending the wires for the o2 can be a pain and if they ground out you're gonna be left stranded somewhere with a blown fuse.

 

i got it to reach but the wires are a little tight... im probably going to have to modify something