I read the DIY write up, but I am not sure if I took everything required out. I have pics. If you have done this, please let me know if anything else needs to be removed before putting them in the oven.

Thank you,
Demetri

 

Can u removed that plug in the middle on your picture 3? If not, then it looks to me like your good to go! GoOD LUCK!

picks after!

 

no need to bake man...i did my headlights...i used a blow dryer...take your time...use the blow dryer and a flat head screwdriver...good luck.

 

for me using a heat gun was better since you can control it better . point and shoot..... but in your case everything looks ready to go in the oven good luck

 

The 2 clear ones?

If you're referring to the darker l shaped plug (i think). I removed it after taking the pic. There were 3 actually in total

 

Might want to take those rubber vent tubes off.

 

how long did it take you with the blow dryer?

 

Yah I just did. there are 3. thanks!

 

took less that 10 minutes to take the cover off with the blow dryer...

 

what i did was: blow dried the edge where the glue is...heated up the whole border...then start at one corner...(its good to have a friend holding the blow dryer)...have them point it where you're prying...id recommend gloves...it gets a lil hot...lol...

the reason i did it with my blow dryer is because i didnt want to risk over baking my headlights or just something going wrong...

hope you try it this way first...it'll work!

 

When I'm prying I im bending the black plastic? is that normal