Notices
Evo General Discuss any generalized technical Evo related topics that may not fit into the other forums. Please do not post tech and rumor threads here.
Sponsored by: RavSpec - JDM Wheels Central

clutch pedal issue

Old Apr 20, 2011 | 04:41 PM
  #1  
mrevo331's Avatar
Thread Starter
Newbie
 
Joined: Mar 2011
Posts: 61
Likes: 0
From: USA
clutch pedal issue

after i do a pull in my car, the clutch pedal like bleeds down about halfway. what causes this?

i can drive the car normal all day and it wont do it, it only does in when im WOT doing a pull. it does it about 90% of the time also. if i pull the pedal back up it stays up and will not go down again until another pull.
Reply
Old Apr 21, 2011 | 03:41 AM
  #2  
yuzzimi's Avatar
Newbie
 
Joined: Jan 2010
Posts: 16
Likes: 0
From: Westchester
Me too

I have a similar problem, does the engagement point change too?
Reply
Old Apr 21, 2011 | 09:43 AM
  #3  
Blue95GST's Avatar
Newbie
iTrader: (1)
 
Joined: Dec 2007
Posts: 52
Likes: 0
From: Maryland
I know it seems basic, but check your fluid level lol, happened to a friend and no idea if it was coincidence o timing, but it fixed his problem
Reply
Old Apr 21, 2011 | 03:03 PM
  #4  
mrevo331's Avatar
Thread Starter
Newbie
 
Joined: Mar 2011
Posts: 61
Likes: 0
From: USA
checked the fluid and its topped off
the engagement point seems to change a little. it also seems like when it happens, and i try to grab the next gear, its like the clutch isnt fully disengaging
Reply
Old Apr 22, 2011 | 06:06 AM
  #5  
spooldursti's Avatar
Evolving Member
iTrader: (1)
 
Joined: Dec 2010
Posts: 135
Likes: 0
From: Topeka ks
Check to make sure your slave cylinder isn't leaking. It might be leaking out of the line that goes to it from the master cylinder.
Reply
Old Apr 24, 2011 | 07:31 AM
  #6  
mrevo331's Avatar
Thread Starter
Newbie
 
Joined: Mar 2011
Posts: 61
Likes: 0
From: USA
checked whole system today. no leaks at all
Reply
Old Apr 24, 2011 | 07:45 AM
  #7  
evo9nuuub's Avatar
Evolving Member
 
Joined: Dec 2009
Posts: 181
Likes: 0
From: pensacola
you either have air in the system or a bad master cylinder,, try bleeding it first.. the fluid should be clean bc it is technically a sealed system i would say you have air in the line somewhere
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
bbong
Evo Engine / Turbo / Drivetrain
5
Jun 11, 2017 05:25 AM
Kris86
Evo Engine / Turbo / Drivetrain
4
Oct 5, 2016 10:31 AM
red_evox_87
Mitsubishi TC-SST Discussion
2
Jun 13, 2016 09:00 AM
cts4g63
Evo General
3
Jan 6, 2016 02:22 PM
Roger350
Mitsubishi TC-SST Discussion
4
Sep 24, 2013 09:48 AM


Thread Tools
Search this Thread

All times are GMT -7. The time now is 02:58 PM.