Hello guys,
I've been searching for its location for ages now, and hope that the lovely folk on this forum will help me finally finding it!

I cant hear it running while pressing accelerator with ignition on ... it was running fine , just 3 lights came on the motorway, and never worked since... was perfect before...

Some said its somewhere close to the battery- i took a picture, could anyone mark it up on my pic?
Where is the Relay/fuse that gives the power to our wonderfull ACD system??



Would be very greatfull! And if it will sort my problem out will be happiest evo owner in UK

Kind regards!
Dimitry

 

For us Americans it's supposedly here (red arrow), but I don't know cause I haven't
had to mess with the ACD, thank goodness. Sorry I couldn't be more help..

 

the fuse is on the positive battery terminal..

another cause of your problem could be a broken pressure sensor on the pump

Also check the wires in the kick panel by the driver and co driver's feet.. .check for corroded connectors

 

Thanks guys!! Great answers!!!
Where exactly on the positive battery terminal, cant see any fuses there...
How is that pressure sensor checked? Is it still a diy job to replace it? Or its a massive thing that needs the pump out etc (where is the pump itself then??)

Which wires I should exactly check there? I heard of this problem, but not sure were and how to start

Otherwise-HUGE thanks guys!!! This will start me off with something... hope I can comeback one day and say-sorted with the help of the forum, not garage )

 

the fuses are on the positive battery connector.. under those clear plastic covers..

as for the wires.. in the driver and passenger footwells... left and right, there is a big plastic corner element covering the sill... take it off and you will see a couple of connectors, on each side... check them for corrosion..

as for the pressure connector.. that one is not easy to check.. the pump on EU and UK and JDM cars is behind the rear left wheel..

 

which one is it on the positive terminal? there are two plastic covers, and i am only seeing one fuse on the right side when you're looking at it. is there supposed to be a fuse on both sides? and which one is for the ACP pump?

 

If you don't see a metal bar underneath one of the plastic covers, the fues has popped and you will need to replace the whole connector.