I've have recently completed an engine swap from a 6 to a 5 motor. I have a Powerfc that came with the 5 motor. I went to go start it and I was only running on two cylinders. Pin 10 is only supposed to read .2v-.4v with the ignition on. Currently it's reading 6v from pin 10 (cylinders 2-3). Pin 23 (cylinders 1-4) is reading .2v which is correct. I don't want to fry the coils so I'm trying to avoid any other issues. There's is only one post out there about this problem and I'm trying to get more insight on how to fix this. If anyone out there has any kind of answer, it would be greatly appreciated...