No open loop?
No open loop?
so I have been having this issue lately when trying to get into boost where I keep getting knock now when I run a log I have noticed that my timing doesn't seem to go lower then 22* when its target is significantly lower in the targeted cell. AFR reads correct for what it should be around .3 away from target but its like the timing wont cooperate. I can run any log needed and post it up but some help with the wealth of knowledge on here would be greatly appreciated.
Thread
Thread Starter
Forum
Replies
Last Post
Slava
ECU Flash
5
May 7, 2007 06:11 AM
silverstream
General Engine Management / Tuning Forum
1
Oct 2, 2006 08:34 AM




