i just bought a sparco harness bar and 2 sets of 4 point harnesses to go with it. 48" shoulder belts and 36" lap belts. The harness bar is installed and the shoulder belts are rigged, now the only problem is installing the lap belts. I have hardware that's obviously for the lap belts, and i'm just kinda wondering where i should anchor the lap belts. is there drilling required? is there somewhere where they bolt into with the hardware? if anyone has done this before with the harness bar and could help out that'd be greatly appreciated. thanks!

 

I don't have the harness bar, but my lapbelts are mounted where the OEM anchor points are. You need to take out the center console to access the middle seat belt anchor points. To remove the center console, just take out the 2 screws inside the armrest.

 

ahhh, thanks. now, as far as the outside mounting points are concerned, should i just bolt em in at the base of the B-pillar where the stock seatbelt mount is? (that's the same place where the bottom of my triangulation bar for the harness bar was bolted in)

 

Call Sparco and they'll be more than happy to help ya out and/or check out sparco's website.