Finished my gauge/radio swap...but

Reply Subscribe

Thread Tools

Search this Thread

Feb 16, 2006, 04:16 PM

Mr.IX

Evolving Member

Thread Starter

Join Date: Jan 2006

Location: Florida

Posts: 245

Likes: 0

Received 0 Likes on 0 Posts

Finished my gauge/radio swap...but

I finished the swap last night, it took me a while because i couldn’t figure out what the radio was caught up on. Only one problem... the radio fit PERFECT.. as i went to install the guages the screws did not line up correctly.... i could only fit the left bottom and top right screws in. Alignment was slightly off so the other screws were going in crooked so i just left em out. It looked good nice space in-between the sides and all... Ill post pics soon. ANY1 ELSE have this problem???

Reply Like

Feb 16, 2006, 04:52 PM

evo8rcr

Evolved Member

iTrader: (2)

Join Date: Aug 2005

Location: palm desert and san diego ca

Posts: 743

Likes: 0

Received 0 Likes on 0 Posts

Reply Like

Feb 16, 2006, 09:10 PM

pog0

Evolved Member

iTrader: (17)

Join Date: Nov 2005

Location: San Diego

Posts: 557

Likes: 0

Received 0 Likes on 0 Posts

My radio fits perfect down below, but my gauges up top are slight crooked. Left part is more flush than right side.

Reply Like

Feb 17, 2006, 12:42 AM

EvoSid

Newbie

Join Date: Dec 2005

Location: Hobbs, NM

Posts: 59

Likes: 0

Received 0 Likes on 0 Posts

yeah same here, I ended up using just the top two screws on my gauge panel. I also rotated all three gauges slightly clockwise for that mad tight JDM angled look.