Anyone installed it with an APR splitter?

 

Anyone know if this fits with the Ralliart splitter? How does it compare to the Buscher?

 

Bumping an old thread.. does anyone have the instructions or pics of the instructions on how to install this? Picked up a used one and don't have any install instructions. Thanks

 

I don't underunderstand this step:
And install the Beatrush Undertray Brackets so that the lower end w/ Welded Nut is facing forward (see Diagram, Bottom of Illustration #3).

The 2 brackets I have that look like they match the diagram do not have a welded nut.

 

I'll take a look when I get back from the track.

 

I figured it out. I had to use the "nut tabs". Maybe Beatrush changed the design over the years?

I do have a slight vibration noise at low RPMs in 1st and 2nd. Any ideas what this could be?

I know years ago you mentioned that you use racing ramps to I believe access tow hook cover before jacking the car. I'm wondering if raising the car between 2.5" to 3" would all for enough room to unscrew the screws attaching the tow hook cover.

I also have a lot of left over screws, washers, crush washers and some "nut tabs" which is scaring me lol

The install took me 4 hours because I suck.

 

To remove the tow hook cover I just reach under the car, but I have long orangutan arms.

Grats on getting it installed!

 

The under tray can vibrate against anything really, it's a large sheet of aluminum.

Once my car was modded, I gave up trying to chase down all the strange noises/rattles that don't sound like grinding or anything serious.

 

Thanks!

I have pretty long arms as well and don't think that will be possible without something like dzus fasteners for the tow hook cover. I think adding the dzus fasteners to the tow hook cover will be doable for me with the clip-on dzus fasteners, although I am nervous about drilling the panel

Yeah you're right... It is a race car after all...

 

What do you have to drill? I only ended up using a drill once to modify the panel to ease fitment.

 

The fastener won't fit through the hole.




The two types Chris included with the panel are the Kurvey Girl Rivet-On 12mm length (D8) and the Kurvey Girl Clip-On 14mm (D3). I think they are the "older" ones. Maybe there is a newer one with a smaller diameter fastener?

 

Gotcha. Drilling it out is no big deal as far as I'm concerned.

 

and bump!......

just a fyi, i installed this on a evo 9 with non se lip and everything fit perfect!. i have a works cross brace, and ets front mount, and a voltex lip. all fits perfect! great looking tray, its a shame its not visable and i scrape it from time to time because im stupid low!

 

Anybody know where i can source mounting brackets? Bought a used one and its missing all the mounting brackets and hardware that mount to the car.

 

ups. anyone having issues with the fitment? mine cant fit due to the ic pipe (not licp)