Anyone know how to remove the abs sensors, located on wheel hub area, without damaging them? An installer somehow messed up something on my ABS system, during a clutch install, so I now have an abs light on the dash. I wanted to see if any of the front sensors were damage.

I took off the bolt that holds it place, but that ****** is stuck on there like it was glued.

the sensor i'm talking about is listed as #1 on the image below.


any help would be great. It's pissing me off cause it was something cause I want my car 100% functional, especially my brake system.


thanks....

 

Wiggle, twist a little and pull straight out.

 

Will try again... I did all that but wouldn't budge.

is the sensor sturdy at all? I was ready to use a hammer on it.

 

Hammer = BAD!!

 

did this work? I tried to remove one of mine but stopped because I was worried it would break?

 

so I replaced one of my sensors tonight... I tried everything possible to remove it without damage but I couldn't so in the end I had to destroy it to get it out...

I have no idea how people can remove them without damage ?????

 

I having this same problem with my left rear one, I took the bolt out and then tried to move it but it will not move what so ever I throwing a code for that sensor so I was going to take it out look at it but looks like I might have to destroy it to get it out help please!!