Gauge, vacuum hose....goes through where??
#1
Evolved Member
Thread Starter
iTrader: (7)
Join Date: Aug 2003
Location: TN
Posts: 2,857
Likes: 0
Received 0 Likes
on
0 Posts
Gauge, vacuum hose....goes through where??
for the guys that have done a boost gauge, I am going to install mine in the DIN, and was wondering how you guess ran the hose through the firewall?? I want to avoid drilling if possible, but if not then
#4
Evolving Member
iTrader: (1)
Join Date: Jun 2003
Location: Coming to a South Loop near you
Posts: 211
Likes: 0
Received 0 Likes
on
0 Posts
if you take the glovebox off and shine a good flashlight in there, you will see it on the firewall. You can also see it looking down thru the engine bay in the back corner (passenger side, obviously). I poked it out with a long handled feather duster from the inside
#5
Evolved Member
iTrader: (3)
Join Date: May 2003
Location: NW PA
Posts: 1,014
Likes: 0
Received 0 Likes
on
0 Posts
Hey Technoz, I saw your A-pillar setup. Very nice . I assume you have a mechanical boost guage??? I was wondering if you able to run your vacuum hose all the way to (and through) your A-pillar without kinking any airlines? I was thinking about getting a mech boost gauge, but wasn't sure if it would work on the A-pillar.
Thread
Thread Starter
Forum
Replies
Last Post
NJ_evoIXgsr
Evo How To Requests / Questions / Tips
0
Apr 19, 2009 04:26 PM
80210
Evo How To Requests / Questions / Tips
1
Feb 17, 2007 02:10 AM
inariv5573
Evo How To Requests / Questions / Tips
13
Jul 31, 2004 12:59 PM