Defi boost gauge install w/ pics

Reply Subscribe

Thread Tools

Search this Thread

Oct 10, 2009 | 08:58 PM

#106

funks

Evolving Member

iTrader: (4)

Joined: Jul 2007

Posts: 488

Likes: 0

Quote:

Originally Posted by 80210

I have a question for you. On your write up you tapped the T piece into the FPR on the top of it... evomoto's installation they tap into the side of it. Does it matter? Thanks.

Here is the picture from Evomoto's installation.

Sorry for bringing up an old thread..

In regards to EVOMOTO's picture, why is the vacuum / pressure source the line after the fuel pressure solenoid (between the solenoid and the fuel pressure regulator)? And not before? (the line between the manifold and the fuel pressure solenoid)..

I don't get it, doesn't make sense that it's after the solenoid because if the solenoid is being switched by the ECU, the pressure / vacuum reading will be affected. If it's before the solenoid, then when the ECU uses the solenoid - shouldn't affect the vacuum / pressure reading.

Last edited by funks; Oct 10, 2009 at 09:00 PM.

Aug 4, 2015 | 02:13 PM

#107

VishnuEvo8

Newbie

Joined: Jun 2015

Posts: 9

Likes: 0

From: Virginia

I know this most is more than 10 years old but I have used this post a few times to remind myself where I can tap into for lighting. The images were hosted on another site and the links are dead.

I would take new pictures but it would be great if we could somewhere salvage this great how to.