patan

where i can find the web page of the torque of each arp head stud, instalation of evo.?

93h22cvc

usually torque the head studs 75ft-lbs all 10 of them.then go back and bring them all up to 85ft-lbs

Quickshift

iTrader: (4)

Work your way from the middle ,torque your nuts to 75ft with the moly lube supplied with the headstuds. Hand tighten the studs into the block, and if you want give it a couple turns with allen wrench but dont make very tight.

This is the order of stud install.


Intake side
^
8 6 1 3 9

10 4 2 5 7
\/
Exhaust Side

Each of those numbers represent a headstud on the head. Just remove and replace one stud at a time, in that number sequence.

Hope that helps some, use evomoto.com and look at there cam install to get an idea of all the torque specs for all the other items attached to the valve cover.

patan

thanks,i get already the idea