EVO RS Trunk Bar Install
#37
Evolved Member
iTrader: (90)
I don't remember what size bolts work but I'm sure if you go to some hardware store and tell them you want to try a couple out and see what works you could find 1 easily...To be honest I think they are almost about the same size as the bolts that hold up the stock chassis bars underneath the downpipe...
#38
Newbie
iTrader: (1)
Join Date: Mar 2008
Location: Virginia Beach
Posts: 26
Likes: 0
Received 0 Likes
on
0 Posts
I went to 3 hardware stores today and couldn't find a single bolt to fit. I think those holes use an M9 thread pitch size? The sizes in stores jump from 8 to 10.
Can anyone verify the size of the bolts? This is pissing me off. Wish I would have known to order the bolts along with the bar, wasn't aware it didn't come with it.
Thanks,
Can anyone verify the size of the bolts? This is pissing me off. Wish I would have known to order the bolts along with the bar, wasn't aware it didn't come with it.
Thanks,
The following users liked this post:
DinoYang (Mar 29, 2020)
#40
Newbie
iTrader: (1)
Join Date: Mar 2008
Location: Virginia Beach
Posts: 26
Likes: 0
Received 0 Likes
on
0 Posts
Thanks Z Lancer... just to clarify , what size should I be looking for at the hardware stores? They seem to list all metric stuff as example: M10, 1.5mm 25mm(length?).
I had assumed the the thread width was M10 and 1.5mm the pitch/spacing?
I test fitted some labled 1.25 which were too small (width) and 1.5's which were too large (width)..
I had assumed the the thread width was M10 and 1.5mm the pitch/spacing?
I test fitted some labled 1.25 which were too small (width) and 1.5's which were too large (width)..
#41
#43
Evolved Member
iTrader: (115)
Thanks Z Lancer... just to clarify , what size should I be looking for at the hardware stores? They seem to list all metric stuff as example: M10, 1.5mm 25mm(length?).
I had assumed the the thread width was M10 and 1.5mm the pitch/spacing?
I test fitted some labled 1.25 which were too small (width) and 1.5's which were too large (width)..
I had assumed the the thread width was M10 and 1.5mm the pitch/spacing?
I test fitted some labled 1.25 which were too small (width) and 1.5's which were too large (width)..
Usually around $60 or so new.
#45
Evolved Member
iTrader: (49)