well i got my hallman mbc and am gonna install it soon but when looking at the directions i seen that there is 2 ways to install it for the air inlet for the boost controoler well my question is which way is the best to do it in your oponion. should i use the T fitting between the bov and the intake mani or off the the turbo houseing what is the most common way to do it and which is most reliable well any info will be great

 

mine's between the bov and mani.....my boy has it the other way, I don't think it matters that much but I'm sure some guru will jump on here and explain to you why his/her way is the best way. Nice choice too, mine's black.

 

also is there any limitations to how much boost u can run with it installed either way or will it be the same

 

should be the same. I think you can bump it a couple psi safely without a tune for now. do you have any supporting mods?

 

yea i got it tuned for an intake and a fuel pump but since than i got a tbe and put the hyper force ignition amplifier

 

Here is a DIY thread with pros and cons of the ways...

https://www.evolutionm.net/forums/sh...=114794&page=2

Put the new parts on and get it tuned with the boost turned up...