STM Now Offers a Front and Rear Lightweight Crash Bar for Your Evo!
#33
Evolved Member
iTrader: (29)
rear beam was perfect. was installing the front crash beam but i realized, as it's just a bar, it doesnt have the inlets that the stock crash beam does - so you see the bar through those two air inlets, as STM's picture clearly shows. I'm not sure if I want this, not because it would make a difference performance wise (it wouldnt) but more in terms of aesthetics
stock - you can see the crash beam through the holes here:
just a heads up. I doubt most people would care
stock - you can see the crash beam through the holes here:
just a heads up. I doubt most people would care
Last edited by kyoo; Mar 10, 2013 at 05:37 PM.
#43
Evolved Member
iTrader: (29)
i thought i'd mention this here - i'm probably one of the only ones who would care about this but: the tabs for the license plate are welded on, and in my case, aren't welded on evenly. the distance is right so the plate will go on with ease, just slightly crookedly. just a heads up. i may dremel the plate a little so it'll match. the uneven tab practically is touching the rear bumper as well, but no biggie there
#44
Hi, i own an evo 9 jdm rear bumper with the jdm license plate, do i have to remove that to install your crash bar?? or i have to buy your crash bar without the license plate brakets
and price shipped to 33177-6400
and price shipped to 33177-6400