We are running a special on the intake spacer thru the end of April, $54.95 shipped in continental US. If you have any questions contact me or you can view the previous thread regarding the spacers.

 

link?

 

https://www.evolutionm.net/forums/sh...d.php?t=129718

 

I have had a few ask about the install, basically its a R&R of the intake, not a big deal. If you can do cams, you can install the spacer. Thanks!

 

Congrats to Curt for running that blistering 10.9 at 124 on the stock turbo! Even tough the spacer is a small part of the equation, its obviously not a hinderance!

 

A great product, but not a simple drop-in

You need to make a few spacers for the accessories.

MachC5

 

i wish you could make spacers for the 4g94/93 head

 

What?

 

Could you clarify?

 

It wouldnt be a problem if there was a market for them. If you get a few people interested I will look into it.

 

^pmed

 

Just take a good look at the things that attach to the EVO's intake....
It's not hard to do....

 

The main source of heat to the intake manifold is the cylinder head. Heat also comes from the EGR, and I make spacers/ block off plates for both. Another source of heat would be the incoming air, which has already been cooled quite a bit by the FMIC. I guess you could make a spacer for the TB, but probably little if any benefit would be seen. Thanks for the suggestions, though.

 

To make ordering a little faster I also have these listed on Ebay for the same pricing thru the end of the month. They are under air intake/fuel delivery, subcategory intake manifolds.

 

The free shipping covers Canada/PR/Hawaii also.