Wow , these look pretty nice for the money .

 

alright i have these in my possesion... it looks as if i could install them myself, but there is 0 room to get back there. Just how hard is this.. what kind of tools are needed, how long does it take and where should i start? Just looking for basic info.

 

Remove the passenger side wheel & the small piece of wheel well liner that covers the crank pulley. Support the engine w/ a jack (so you can move it up and down as needed) and remove the passenger side motor mount. Then w/ a 1/2 inch drive breaker bar release the tensioner from the belt. Then remove the belt and the pullies that are being replaced. crank pulley bolt torque is 19 ft lbs

 

wait.. i thought this was an easy install!!! CRAP!