98 Mirage to Evo 6.5 TME
Thread Starter
Evolving Member
iTrader: (13)
Joined: Jul 2008
Posts: 319
Likes: 6
From: Bellevue, WA
Project's going slowly. Hopefully I will be paying for a hood mid-week. But in the meantime, anyone want to make a SIGNIFICANT donation? I'll repay you with free oil and spark plug changes for life 
http://cgi.ebay.com/ebaymotors/Parts...=p4506.c0.m245
That is probably the pinnacle of all front clips. I can dream can't I?
http://cgi.ebay.com/ebaymotors/Parts...=p4506.c0.m245
That is probably the pinnacle of all front clips. I can dream can't I?
Well i like to share some pictures of my buddies 2000 2 door Mirage 4G63 AWD.
Featured this month in Dsport Magazine, and in the Near future in Performance Auto and Sound is Archie ConCon's 2000 Mirage featuring a TrevTec Racing engine, Full tune by TrevTec, A TrevTec Full Coil on plug setup and custom TrevTec exhaust. Pick up the Dsport this month.
MIKE
Featured this month in Dsport Magazine, and in the Near future in Performance Auto and Sound is Archie ConCon's 2000 Mirage featuring a TrevTec Racing engine, Full tune by TrevTec, A TrevTec Full Coil on plug setup and custom TrevTec exhaust. Pick up the Dsport this month.
MIKE
Thread Starter
Evolving Member
iTrader: (13)
Joined: Jul 2008
Posts: 319
Likes: 6
From: Bellevue, WA
Yeah Archie and I have a good trading relationship. Believe it or not those headlights in the mag are the ones I am running right now. And next week or so that's going to be my hood. I also bought my Evo 6 spoiler from him 
Thread Starter
Evolving Member
iTrader: (13)
Joined: Jul 2008
Posts: 319
Likes: 6
From: Bellevue, WA
I can't believe it has almost been two months since my last update. Wow. Hopefully this will make up for it. I just received and installed my ViS Evo VI carbon hood. Look familiar to anyone? ^^^ No longer will I have to use that POS Mirage hood.
Now as you can tell, there is a bit of a gap on the right hand side. This is due to an offset in the hood latch (since the car was wrecked before). This will be taken care of next week when I put the VI fenders on. No point in fixing new alignment with old parts.
Now as you can tell, there is a bit of a gap on the right hand side. This is due to an offset in the hood latch (since the car was wrecked before). This will be taken care of next week when I put the VI fenders on. No point in fixing new alignment with old parts.
Thread Starter
Evolving Member
iTrader: (13)
Joined: Jul 2008
Posts: 319
Likes: 6
From: Bellevue, WA
I would if I had a fair amount of money to begin with. But I'm just a HS senior, unemployed. It is easier to focus on the little bits than the big picture in my case. If any of you want to donate $2500 for this good cause, I'll get right on it.