Anyone make this or know where I can get one?

I was never into the voltex, cyber etc ones.... to much over kill/ unwanted attention for the street.

I like this since it changes the look of the rear while not being tacky

 

Those are from a GTR z tune

 

Ya I read that somewhere

Does anyone make them/ or willing to?

I love the look the only thing that seems to have the same arch (in my limited search) is the nissan juke rear fender extension http://www.ebay.com/itm/2011-NISSAN-...item415c31bc04

 

well, if you wanna take some measurements I have some very similar flares on my Galant made by Socal Autowerks, here's a pic, I can take some measurements as well and see if they're close.

 

How do they fit by the door opening?

 

I'll take some measurements

How much were those and how are they attached?

PS I miss Oregon, I was a Tigard resident though

 

well, cost depends on 2 factors, material and where you're getting them from. These fender flares on my car are carbon fiber replicas made in California of the JDM VR4 galant OEM flares which are your typical OEM plastic material. The replicas can be made in fiberglass or carbon, I chose to get the replicas because at one point my entire car was covered in upainted carbon and they were cheaper too because you didn't have to pay shipping for the OEM parts which are hard to find used and they cost an arm and a leg new @ a JDM mitsu dealer. I can get the part for you though if that's the route you decide to take. here are some more photos, hopefully it'll give you guys an idea on how they sit.










I attached mine with small rivets because my fenders have been rolled/pulled/trimmed for wheel clearance, they have OEM mounting tabs on them but obviously they won't line up on an evo. Hope this helps guys

 

^that track pic is sick!

 

how much are those overfenders for the galant? I wonder if they fit lol.

 

Mine were around 320 shipped in CF about a year ago, prices have gone up since then but the owner of the company is a vendor on the galant forums so we get deals sometimes
http://socalautowerks.com/products.html.
If you guys are serious I'll go measure them and give you some dimensions. I just dont want to do it and have it be a waste of time.