Well almost. don't have the far back left and right covered or the cd changer mounted yet, or the enclosure on the left covered correctly,, but it sounds great and is finally almost done!!!!

 

 

Lookin good...

 

and you still have full access to your spare?

 

it looks awesome. forgot to write that.

 

looks like it came from the factory.sweet why did you cut over the shocks? do you have a trunk bar going in? that whould look good.

 

Love Phoenix Gold - is that a ZX500?

 

bumps in the trunk = weight

 

lookin good bro

 

Very nice look'n trunk. Clean. Looks similar to what I'm doing with my trunk.

 

lookin goooood

 

very nice, i still think someone should mass produce those peices from a mold i want to do the same for my car.

 

looks great, are those 10" or 12"s, also do you still have access to your spare?

 

Yea guys,, I still get access to the spare tire, the floor just lifts out!,, There is a strut bar going in there as well, just was leaving it out till i had the trunk for sure done!!

For all of you weight ****** out there. the enclosure are made of fiberglass and weight just over 15 lbs each, then chooose your 12inch sub and that is your weight! not too bad!! It is also wired so I only have to use one of them at a time if I don't have a sound off to be at!

My old set up was like 130lb plus. I love fiberglass so much lighter!!!!!

Also the enclosures just pull out.. they are held in by heavy velcro, (and fit snug because their mold was taken from trunk )

Pick of old set up below!!

 

any chance you could produce a few more?