Hey guys, I finished installing my boost and oil pressure gauge this afternoon. My boost gauge is working fine (stock map goes to 18-20 right?) but my oil pressure gauge is reading constant 124-126psi, even when the car is off.

This makes me think it's an electrical issue since it reads when the motor is off.
I'm sure I wired up the connections right according to the instructions, and obviously the power source wiring is working since they both turn on and are wired parallel from the fuse source. Just wondering what you guys think would cause this? I don't think I flipped the two wires from the pressure sensor, but if I did would it cause this?

 

bump

 

Welp, fixed the issue during lunch today. I must have flipped the wires during the install. So the two sensor output wires were reversed, it's all working now!