My turbo oil feed line busted. Got a new oil feed line from the dealership and put it in. I took off the the intake, upper intercooler pipe, the manifold, the downpipe and the turbo just to make sure nothing else was busted. Everything else was good. I got everything bolted back up and no problems except im throwing error codes. I get them read and here is what they are:

P0113(IAT Sensor High Input)
P0014("B" Camshaft Position - Timing Over-Advanced or System Performance Bank 1)
P0172(System Too Rich-Cylinders 1-4)

I cleared them and they came back on. How can I get them fixed/stop popping up?

 

are you sure everything is plugged back up? also P0014 can be caused by too much oil in the motor... is it overfilled? did you break a wire in the MAF connector?

 

Im sure verything is plugged back up properly. Ill check the oil and ill check the all wires on the MAF connector and o2 sensors. Thanks

 

Check the oil, it was a little ovr full. Drained some out. Erased the codes and so far so good. Thanks for the advice evilempire18.

 

hope that was it bro, how did you break an oil line?